Reasons for the shutdown of multi-cylinder hydraulic cone crusher under load conditions

When cleaning the crushing cavity of the multi-cylinder hydraulic cone crusher, it is necessary to start the hydraulic station, and inject oil and pressurize the lower half cavity of the hydraulic cylinder through the lower oil inlet pipe connected to the hydraulic cylinder. At this time, the piston of the hydraulic cylinder is pushed upward, and the support sleeve connected to the hydraulic cylinder is pushed away from the lower main frame, which drives the adjustment sleeve and the moving cone to rise, thereby increasing the discharge opening and blocking the falling of the material; after the cavity cleaning is completed, the hydraulic station When the pressure is released, the hydraulic oil under the piston flows back through the pipeline, the support sleeve falls, and the discharge port is automatically reset.
 

If the multi-cylinder hydraulic cone crusher s*s due to load, the crusher cannot be restarted before the crushing chamber is completely cleaned, otherwise it will cause serious damage to the multi-cylinder hydraulic cone crusher and the crusher motor.

The reasons for the shutdown of the multi-cylinder hydraulic cone crusher under load conditions are as follows:

1. The crusher or the engine is s*ped due to electrical failure or lack of oil in the engine,

2. Too much material entering the crushing cavity of the multi-cylinder hydraulic cone crusher causes the crusher to stall.

3. The discharge conveyor causes the discharge to accumulate and block the crusher,

4. There is an iron block stuck in the crushing cavity of the multi-cylinder hydraulic cone crusher.