Analysis of the reasons why the stone crusher automatically stops after starting

During the use of the stone crusher, sometimes the stone crusher will automatically s* after starting, which will affect the use effect and even cause damage to the equipment. What are the reasons and solutions for the stone crusher to automatically s* after starting?

stone crusher

1. Reasons for the automatic shutdown of the stone crusher

1. Overload protection

When the stone crusher is running, due to too much or too hard material, the equipment will be overloaded. At this time, the overload protection device of the crusher will start, causing the equipment to automatically s* to protect the equipment from damage.

2. Circuit failure

Circuit failure is another reason for the stone crusher to automatically s* after starting. Circuit failure may be caused by problems such as poor circuit contact, short circuit or open circuit.

3. Mechanical failure

The automatic shutdown of the stone crusher after starting may be caused by mechanical failure, such as problems with the equipment transmission system, internal failure of the machine, etc.

2. Solution

1. Check overload protection

When the stone crusher s*s automatically after starting, you need to open the equipment casing and check whether the overload protection switch is loose or damaged. If it is loose or damaged, it needs to be replaced or tightened in time to ensure normal operation.

2. Check the circuit

If there is a problem with the circuit that causes the stone crusher to s* automatically after starting, you need to check whether the circuit is in good contact, or whether there is a short circuit or a break in the circuit, and eliminate the problem in time to ensure the normal operation of the equipment.

3. Eliminate mechanical problems

When the stone crusher s*s automatically after starting, you need to check whether there is a fault in the equipment transmission system, and check whether there is impurities or other objects blocking the machine, and deal with it in time to ensure the normal operation of the equipment.