How to avoid blockage of impact crusher

The impact crusher is generally in the position of medium and fine crushing in the sand and gravel production line, and plays an important role in crushing materials and subsequent production. When the impact crusher is blocked or stuck, it will not only delay the production efficiency, but also waste a lot of time to clean the impact crusher and rectify the sand and gravel plant, resulting in the inability to process the materials processed by the rough crushing equipment. Reprocessing also makes sand making and other subsequent equipment materials available, thus affecting the progress of the entire production line.

The impact crusher is composed of important parts such as plate hammer and impact plate. Because of its simple structure and easy maintenance, it is favored by users. When the wearing parts are worn out, timely replacement or maintenance can ensure that the crushed material is In normal operation, the material can be crushed and discharged smoothly, so as to prevent the material from being blocked.

Since the impact crusher performs crushing work according to the transmission power of the V-belt, the tightness of the V-belt will also affect the crushing effect of the material. A reasonable force will be transmitted to the sheave to achieve normal results. If it is too loose, the force is not enough. , the material cannot be completely broken, resulting in the phenomenon that large pieces of material cannot be discharged in time, and even forced to s*. If it is too tight, the sheave will use excessive force to break the material, the wear will increase, and the equipment will be damaged. Therefore, the staff should pay attention to check the tightness of the V-belt and adjust it in time.

In any link of the sand and gravel production line, the moisture content and viscosity of the material should not be too high. Otherwise, too much material will be stuck in the crushing cavity. Excessive moisture will cause rust in the cavity, damage to accessories, and impurities in the finished material. The content is too high, so no matter it is an impact crusher or other crushing and sand making machines, it cannot be blindly fed. When the operator controls and operates the machine incorrectly, the phenomenon of material blockage may also occur, so the production line needs to be equipped with staff to operate.