How to deal with the cone crusher that has not been used for a long time

Since the main component of the cone crusher is steel, it is easy to rust. The rusted machine will affect the normal operation and easily cause economic losses. Therefore, reasonable storage is the key:
 

1. If the flywheel has been removed from the eccentric shaft, the contact surface between the flywheel and the shaft should be coated with corrosion inhibitor.

2. Run the cone crusher at least once a month during storage or during seasonal shutdowns to ensure that the bearings remain properly lubricated. If the crusher cannot be operated during storage, it is necessary to manually rotate the crusher flywheel 3 to 4 times to ensure that the bearings are properly lubricated. If necessary, add grease to the bearings.

3. If the movable jaw has been removed from the frame, in order to prevent sundries from entering the bearing seat, there should be enough grease in the seal. The bearing seat contact surface on the frame and the frame, the bracket contact surface and the bracket seat contact surface, and the tie rod holes (if applicable) should also be coated with corrosion inhibitor.

4. When the cone crusher is taken out of storage, check the paint condition and repair as necessary. Preservatives should be removed from all contact surfaces prior to assembly of the crusher.

5. The cone crusher and its dismantled parts should be stored on a stable support to prevent contact with the ground.