How to improve the production efficiency of jaw crusher

Reasonable adjustment of the speed of jaw crusher can improve production efficiency. During the operation of the jaw crusher, the speed should not be adjusted too fast, so that the crushed ore in the crushing chamber will not be discharged in time, resulting in blockage, which not only fails to improve the efficiency, but also reduces the production capacity and increases the power consumption.

While ensuring the particle size of the product, the outlet should be adjusted reasonably so that the angle between the movable jaw and the fixed jaw is within a better range, which can also improve the production efficiency of the machine. In the later stage, more attention should be paid to lubricating and replacing parts that are easy to wear, and maintain the machine to keep the machine running smoothly.

From the point of view of the materials to be crushed, the ore materials should not be too wet, if they are too wet, they will easily adhere to the jaw crusher, which will affect the feeding and conveying. Therefore, the moisture content of the material should be reduced before crushing, which can improve the production capacity. In short, in the daily operation of the machine, pay more attention to some small details, which will ly improve the working efficiency of the machine.

Strictly control the amount of feed to prevent excessive blockage. Many companies blindly remodel silos in order to increase production capacity, which often leads to overfeeding.

Since the working principle of the jaw crusher is semi-rhythm, if too much material is put in, it will cause the material to be broken too late, and the broken material cannot be removed in time, resulting in sticky material. Therefore, either cutting or overfeeding affects productivity.

Rhythmic feeding and controlled feeding ensure the normal operation of the jaw crusher. At present, the crushing section of the mineral processing enterprise *ly uses the end chute for feeding, and two-thirds of the entire feeder is exposed outside the warehouse. Due to the remoteness of the feeding port, the feeder has completely turned into a vibrating chute, which not only has poor feeding speed, but also has serious wear and tear. The feeding position of the feeder should be within 1/3 of the * of the equipment, but vertical feeding is strictly prohibited to prevent the equipment from losing its vibration ability or affecting the conveying effect under pressure.