How to increase the yield of 600*900 jaw crusher

1. Strictly control the size of the material  
In actual use, the operator is easy to use the measured inlet size as a larger feed size. Once large blocks specified in the type of E -type crusher model are easy to cause card blocking grooves. As long as the blockage occurs, the equipment will not run normally within a certain period of time.   Therefore, the size of the raw material is needed to ensure the normal operation of the 600*900 jaw crusher.

2. Strictly control the amount of materials  
Many companies have seriously affected production because of the initial insufficient feed, so they have transformed the warehouse. However, due to the lack of restrictions on the amount of materials, the reconstruction warehouse often occurs another phenomenon Essence   Because the working principle of the jaw crusher is semi -rhythm, if you put too much material, it will cause the material to be too late to break, and the broken material cannot be eliminated in time, resulting in the card. As a result, the production and excessive feed will affect the yield of jaw crusher.  

3. Rhythm and feed, control the supply of supplies At present, the crushing section of the mineral selection company is *ly used to use the end -of -the -part slotting of the material. The entire 2/3 of the feed machine is exposed to the position as a whole. Due to the remote granting mouth, the material for the feed equipment has completely become a vibration groove. The feed speed is not good and the wear is severe.   The better materials for feeding machines should be at the * of the equipment at the * of the device, but it is strictly prohibited from vertical feeding to prevent the device from being pressed to lose the vibration ability or affects the conveying effect.